How to Do Roofing Shingles

how to do roofing shingles

The first step in figuring out how to do roofing shingles is to measure the size of your roof. For most shingles, you can estimate the length by measuring the width of the roof and multiplying that number by three. This will give you the number of bundles you’ll need. Next, measure the length of each shingle. Most asphalt shingles are three feet long, so the length of your roof must be a multiple of that.

Lay the starter course, or strip. This is the first layer of shingles on the roof. Make sure to leave enough space to overlap the drip edge. Use cap nails to attach the felt to the plywood. Cap nails have a larger nail head and a small tack in the center, which means they’ll be less likely to tear your felt. Continue with the next full course of shingles until you’ve covered the entire roof.

If you’re unsure of how to do a roof, consider using a two-foot-wide shingle that is at least eight inches wide. Then, lay the tar along the bottom edge of the roof. Then, lay a row of shingles, upside down, across the bottom of the roof. If you have a low pitch roof, this could pose a problem. If you’re unsure of your shingle’s width, lay a few strips to check that the shingles are level and that there’s enough room.

As you can see, roofing shingles is a complicated process. The main key to a successful job is planning everything well in advance. Make sure to calculate your waste so you can avoid any unnecessary waste. You never want to risk injury while doing the work. In addition to planning the cost, consider safety and use the services of a professional for extra assistance. This will help you use your time and body more efficiently. And, it will make the whole process safer.

If you’re not sure how to do roofing shingles, you can consult a contractor who specializes in building interiors. Mark Spelman is a General Contractor in Austin, Texas. He has been in the construction industry since 1987. Mark Spelman explains the importance of timing and temperature when installing shingles. Mark also answers common questions about starter shingles. It’s important to know the proper temperature for roofing in your area.

After laying down the tar and the shingles, you’ll need to lay down the first layer of metal flashing. Cut a couple of inches from the vertical part of the shingle and run it past the side wall. Then, use a roofing gun to nail the flashing into place. The shingles should then continue on their way up. If you’d like to add vents, make sure to place them in areas that need them. To measure for this, you can type the dimensions of your attic into an online calculator. Once you have done this, you can cut the vents using a circular saw.

If you’re replacing an entire roof, make sure to install new underlayment and flashing. This may require tearing off the old roof. Before laying down the new shingles, remove any old nails. Always pound flat nails to avoid damaging your new shingles. Tarps are important to protect your landscaping and prevent thousands of nails from raining down. If you live in an area with high winds, you must install four number nine hex head screws.