How to measure for metal roofing can be one of the most important steps towards having a good-fitting roof. In addition to it’s obvious importance, the process of measuring metal roofing is actually quite time-consuming and many homeowners might not think that they have the time needed to make the effort worthwhile. Fortunately, with the help of this article you should easily be able to understand the basics and how to measure for metal roofing.
As you are probably already aware, measuring a house for roofing is one of the most important steps in the construction process. Not only is it one of the most important aspects of house building, but it is also a critical step when it comes to making sure that you get a good deal on the roof. Metal roofs are often considered to be quite expensive, so in order to ensure that you get the best price and the best quality materials, it is important that you take the time to learn how to measure properly. This will ensure that you are ensured that you have made the right measurements and that you are buying a good quality product.
So, just what exactly should you be using when you are doing your measuring? First and foremost, you will want to use a tape measure to make sure that you are getting an accurate reading. In addition to being accurate, you will also want to make sure that the tape is level. If the metal roofing you are measuring is one that is a bit off in any direction, such as too low or too high, you might end up with a measurement that is too short or too long. To avoid these issues, you will want to make sure that you measure off both sides of the roof and use a marking pen to make certain that you are holding onto both sides at all times.
Once you know how to measure for metal roofing, you will need to go about measuring the metal correctly. The first thing that you will want to do is take a standard hammer and strike your mark in the ground. Keep in mind that while metal is extremely heavy, it is also very flexible. When you are hammering your mark into the ground, you will want to be certain to keep the ground in a level position. If you do not, you could find that you do not get the precise amount of distance that you expected.
Once you have struck your mark, you will then want to move forward and start to measure for metal roofing according to the length of the metal. Start by measuring from the bottom run of the rafter to the top run of the spool. For the rafters, you will want to measure from bottom to top. The height of the gutter will need to be measured as well.
The last thing that you will want to remember when learning how to measure for metal roofing is to remember to add one inch to your measurements for each side of the rafters or the top and bottom of the gutter. This will help make sure that your measurements are accurate and that you have enough space to securely install your metal roofing materials. This is especially true when cutting your material to size. If you are unsure how to measure for metal roofing, you may want to enlist the help of an experienced professional to help you out.